How to Wire Up the Colight Apex 4.5" Lights Using the OX Ford

Let's face it: dealing with wiring on a motorcycle can feel like defusing a bomb. Especially when you're working with something like the Colight 4.5" Apex series—these bad boys pack a punch with their 5 pin setup and slick dynamic DRLs, but figuring out how to hook them up cleanly, control everything from one spot, and keep your sanity intact is a major headache for a lot of riders out there.

To crack this nut, we teamed up with veteran moto-builder and off-road junkie Rides with Richie. We put the Apex lights through a full garage makeover and a grueling night test to show you how to get it done right.

The Secret Weapon: The OX Ford Power

If you’ve been in the off-road game for a minute, you already know about high-end CAN bus gizmos like the Hex ezcan, or setups from Lone Rider and Denali. They’re awesome for cleaning up wiring, but man, do they hurt the wallet.

Enter the OX Ford Hub.

Image sourced from the internet

It saves you from the classic headache of tearing apart your bike just to find a switched live wire every time you add auxiliary lights, heated grips, or whatever else you're bolting on.

How it works: It’s a compact little distribution box that centralizes all your accessories, meaning you can finally stop spider-webbing a dozen wires straight to your battery. It has LED status lights to show you what’s drawing power, and an auto-shutoff feature tied to your ignition so you never accidentally drain your battery overnight.

Think of it like a high-end Moto CAN controller, but at a fraction of the cost—under $25 bucks! Way cheaper, way cleaner, and infinitely simpler.

The Wiring Battle Plan (Richie's BMW 1150GS Setup)

Wiring a BMW 1150GS can be a real pain because the battery sits deep down, usually forcing you to strip half the plastics and frame just to get to it. Luckily, the OX Ford makes life way easier.

  • The Initial Plan: Richie first hooked the positive and negative straight to Port 1, and tied the ACC wire into the taillight. But after blowing fuses on Ports 1 and 2, he had to pivot (always mind your power draws and fuses, folks!).

  • The Winning Setup: Moved the ACC wire over to Port 3, kept the main power leads on the battery, and hooked the strobe trigger wire straight to the horn. (Pro tip: You can also tap this into your high-beam switch for that instant "get out of my way" passing flash—check out Richie's latest video for how he tied it into the high beams!).

The payoff? The ACC wire ensures juice only flows when the engine's running (saving your battery), honking the horn gives you an instant strobe burst, and your high beams handle the extra flash-to-pass action.

The best part? The whole setup is stupidly clean. No messy electrical tape, no sketchy wire-stripping in the dark, and no special tools required. Even if you're a total garage beginner, you can hook up just the ACC wire and instantly unlock all the features of the Apex 4.5"—from the killer high/low combos to the slick white sequential DRLs and dual strobe modes.

Night Test: Lighting Up the Backcountry

Let’s just say the spread and raw punch of these lights completely transform night riding. Say goodbye to factory candle-power.

Apex Low Beam

Combo Beam

Before

After

 

The Verdict: If you want central control, effortless wiring, and zero headache, the OX Ford is an absolute no-brainer. Skip the pricey custom shops and do it yourself right in your garage.

Break the mold. Build your Apex off-road rig your way.

👉 Click here to shop the full Apex series and gear up!